User Tools
настройка_командных_интерпретаторов
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
настройка_командных_интерпретаторов [2021/05/11 13:56] admin [bash] |
настройка_командных_интерпретаторов [2022/06/28 08:53] val [bash] |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| scn2() { | scn2() { | ||
| scp $1 node2:$1 | scp $1 node2:$1 | ||
| - | } | ||
| - | |||
| - | ssn() { | ||
| - | DST_HOST_NUM=$1 | ||
| - | shift | ||
| - | ssh node${DST_HOST_NUM} $* | ||
| - | } | ||
| - | |||
| - | scn() { | ||
| - | scp $2 node${1}:$2 | ||
| } | } | ||
| ... | ... | ||
| Line 45: | Line 35: | ||
| $ source .bashrc | $ source .bashrc | ||
| + | # cat /etc/inputrc | ||
| + | или | ||
| $ cat .inputrc | $ cat .inputrc | ||
| </code><code> | </code><code> | ||
настройка_командных_интерпретаторов.txt · Last modified: 2022/09/11 10:08 by val
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
